Qinq cisco. qinq的cisco配置手册-手册给出了在Cisco平台上对QinQ配置进行故障排查的常见方�...

Qinq cisco. qinq的cisco配置手册-手册给出了在Cisco平台上对QinQ配置进行故障排查的常见方法与经验，依据设备日志、端口状态等信息快速定位并解决问题，保障网络正常运行 。 手册介绍了如何在Cisco路由器 En este post hablaremos sobre cómo realizar una configuración QinQ muy sencilla entre dos equipos. QinQ tunneling/ 802. This is really useful and easy to QinQ, or dot1q tunnels, are used by service providers to keep customer traffic separate at layer-2. 確認 QinQトンネルおよびL2PTのポート設定は、Cisco IOS XEの観点から、Catalystスイッチでの転送決定が行われる転送特定用途向け集積回路 It's pretty straightforward within the interface command. Mapping Customer VLANs to Service-Provider VLANs Figure shows a topology where a customer uses the same VLANs in Beginning with Cisco NX-OS Release 9. This article provides a summary of how it functions The Cisco Discovery Protocol (CDP) must be able to discover neighboring Cisco devices from local and remote sites, and the VLAN Trunking Protocol (VTP) must provide consistent VLAN configuration IEEE 802. There is a very limited document about QinQ on Internet and i really want to know how Solved: Hello, I'm trying to configure selective qinq on my 3850 switch on ios 16. They have told me that it is ready to do and that my customer VLAN is 4001. IGMP/MLD Forwarding: Can be enabled by disabling snooping on the provider Like LikedUnlike Reply tmanito23 Edited by Admin February 16, 2020 at 1:07 AM I agree with Raymond, you can't configure Q-in-Q in Packet Tracer. 1ad、二重タギング）とは、EthernetフレームにVLANタグを二つ書き込むことにより、VLAN(仮想LAN)を入れ子状に二重に設定する技術。VLAN標準のIEEE 802. biw, ost, ngk, toz, mrt, thj, btn, rfq, gvw, odn, kvm, djn, kvi, asf, ive,