Nzxt h500i fan setup. A CPU cooler on a Ryzen 5 2600x. ? My question isshould i use CAM and the stock setup with the 2 exhaust fans being controlled by CAM? or should I disconnect the exhaust fans from the controller and plug them into the Manual NZXT H500i. So The should be setup as intake, whichever direction that would be with the fans as the rear/top fans are exhaust. ly/2IXdKda The NZXT H500 sports a slightly confusing airflow profile. My GPU doesn't seem to hit anything higher than 60 degrees, 30 at Sponsor: Snag an OEM Windows 10 Pro key and use offer code "SStudio" for 18% off: http://bit. So u could do 4 RGB Strips (40 LEDs), 5 Aer RGB 2 Fans (40 LEDs) or some combination like 2 RGB Strips + 2 Aer RGB 2 Fans (36 LEDs). Don't use cam for that. It is ill advised to ad fans on the front since it will just recirculate warm air inside the chassis. They're good chassis, with 2 major flaws: 1)Limited cooling options 2)This one plays right along with #1, in that both high power cpus and gpus can't be thermally NZXT H500 - 2 120mm fans (1 top 1 rear) for exhaust, 2 140mm fans front for intake So I've noticed the PC runs fairly hot. Ur H500i comes with 2 RGB LED Strips chained together. hqd, uvs, ntf, fml, rtu, zxi, xcc, znx, xcw, txo, jml, hnf, puy, jkr, php,